Adding the family jewels

We stay busy on the Fox & Hounds project and it’s many, many pieces. One of the signs is almost ready for paint. There were a few details yet to do. After gluing in the support structure I needed to finish the edges and back of the sign. I took a few minutes and used the die grinder to add a subtle texture to the areas. It looks a lot like it was dome with an adze or flat chisel.
The other details would be hand done as well. Back a few weeks ago, when I was doing the workshop in Toronto, I was getting a few supplies (stir sticks and paint cups) and I found these large plastic rubies. They were perfect for the jewels I needed in the crown of this sign. It only cost a couple of dollars for a good sized plastic tube. 
The tops of the crown was sculpted with Abracadabra Sculpting epoxy. I used the die grinder to hollow out the sockets for the plastic jewels. I made them oversized and then partially filled them in with sculpting epoxy, then pushed in the jewels.
I trimmed the sculpting epoxy around the jewels and then fashioned some claws to look authentic. As quick as that this portion of the sign was ready for paint.
Then I used a little more Abracadabra Sculpt to fashion some grape leaves and fastened them to the sign. A couple more seconds with the die grinder introduced a subtle texture to the face of the scrolls.
Stay tuned for the painting process…
-dan

Published with permission from precisionboard.blogspot.com. Source.