We’ve had our trade show booth for the International Association of Amusement Parks and Attractions EXPO in our show for a number of weeks now. Each time we have a few spare minutes we work on it. Our goal is to have it finished in plenty of time for the show – without having to burn the midnight oil or have to do a rush job getting ready. The show is too big an investment and far too important to do that.
Since my last post here on the blog we’ve done a lot of work. Many routing files have been prepared and we’ve routed two or three sheets worth is signs and display pieces for the booth. Lots of steel has been cut and welded into place as well. We added new wings to the booth to stretch it out to twenty feet wide. This will allow us more room to meet with those who drop by and show our work much better than the crowded booth we had last year.
New shelving was cut with the MultiCam plasma cutter and welded up. We still have a few details to finish up. I need to design and route a border for the cork board on the right side. On the left we’ll create some texture sample board which will go behind the viking ship. (brown paper marks the spot.) And in the centre panel we’ll mount a couple more small samples. Then we’ll go over the whole display from top to bottom and give it a good clean and touch up any small dings before we package it up and send it on the way to Florida. The trade show is coming fast!
Share our content!