The rails for the train require plates and spikes to make them look authentic. These will be glued into place but once finished with the rust paint will look pretty convincing.
The vectors were pretty easy and all created inside EnRoute.
I created a flat relief with a bevelled edge using the bevel tool by limiting the height.
Then the spike was added using the dome tool. Once again I limited the height to give it a little flat top.
I needed enough pieces to fill a 4’x8′ sheet of 1″ thick 30 lb Precision Board and EnRoute makes this easy with the duplication tool. I set the spacing to suit the tool size I was using.
Share our content!