Ten Tips For Working With Precision Board Plus HDU

1. Carbide cutters are not mandatory when cutting Precision Board Plus. Because it is non-abrasive, Precision Board Plus can be cut with anything that cuts wood, but much easier.

 

2. To maximize CNC efficiency and cutting time, and to minimize dust and increase chips, the Onsrud Router Bit Selector Guide provides guidelines for proper router bits, speeds and feeds.

3. After you have primed Precision Board Plus using FSC-88WB Primer/Filler, it is best to dry using a large shop fan. Do not place in the sun, as this will cause it to dry too fast resulting in blisters. The FSC-88WB Primer/Filler training video can be seen here.

 

4. Be sure to prime and paint all sides of your Precision Board Plus sign. Because it does not have grain, it has no beam strength and can be pulled in the direction of the drying paint.

 

5. When sandblasting Precision Board Plus, use a larger grit for larger texture. Similarly, a finer grit allows for finer texture. Aluminum oxide is used most often.

 

6. If something happens to your sign during the build process, it is possible to fix the damaged surface. FSC-360WB Crack Filling & Repair Putty dries quickly and sands easily, and can really save the day in the event of a mistake.

 

7. Optimize your Precision Board Plus purchase by bonding and laminating the excess using PB Fast Set or PB Bond-240 adhesive.

 

8. PB Resin can provide an eye-catching, ultra-smooth protective finish to your sign. Be sure to only add enough lettering enamel to the clear PB Resin that will hide text on a printed page.

9. If you do not have time to route in wood grain, or to sandblast, TSF-45 or PB Hardcoat are excellent time saving alternatives for simulating wood grain. Apply both directly to raw Precision Board Plus, eliminating the priming step.

 

10. If you have a question, call us! We offer free technical support and are happy to assist in any way we can.