Horse head routed

Things were a little crazy in the shop while so much was going on but through it all the MultiCam was busy churning out creative work.
I sliced the horse’s head in EnRoute, then tool patched it and sent it off to the MultiCam. It was routed in four layers of 1.5″ 30 lb Precision Board.
The smaller bits and pieces were eliminated for I’ve found then easier to sculpt them in by hand later with sculpting epoxy, less work than trying to glue and carve them.
Here’s the second layer laid on top of the first. Things lined up perfectly.
And here’s the horse’s head ready to glue up.
Tomorrow I’ll route a base and then glue everything together. Stay tuned…
-dan

Published with permission from precisionboard.blogspot.com. Source.